BigRep STUDIO Betriebsanleitung Seite 73

BigRep STUDIO
›
Step 2: Calculate the off sets with a resolution of 0.1 mm
– Print the G-code
of 0.1 mm.
– When the print is finished, wait until the bed is cold and release the part
off the bed.
– Identify the off sets. The shapes printed with extruders T0 and T1 should
match just in one point. Identify the point in which they match and
write down the off set using the template below.
– Go to the Advanced Menu, update the off sets (add the new values to
the previous ones) and save.
Step2_XY_STUDIO_Gcode
Fig. 7-5 : Template – on this example: X off set = 0,3 mm, Y off set = +0,1 mm
Fig. 7-6: Off set adjustment
Operation and Control
7
which has a resolution
73