Cleaning And Care - Klarstein Powericer ECO 3 Bedienungsanleitung

EN
20

CLEANING AND CARE

• Clean the inner liner, water box, ice shovel and evaporator frequently. When
cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water
and vinegar to clean the inside and the outside surface of the Ice maker. Do not
spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil.
Rinse thoroughly before starting.
• Keep ventilation openings in the appliance enclosure, or in the built-in structure,
clear of obstruction. Do not use mechanical devices or other means to accelerate
the defrosting process, other than those recommen- ded by the manufacturer.
• If the machine is reused after a long time , maybe the water pump cannot pump
sufficient water due to the air inside, the ADD WATER water indicator light will turn
on in this case . To correct this press the START button again, then the machine will
work normally.
• To ensure the cleanliness of the ice cubes, water in the water reservoir should be
replaced every 24 hours.
• If the compressor stops for any reason such as water shortage, too much Ice, power
off, etc... Do not start the system right away, wait 3 minutes, and then re-start the Ice
maker.
• Always change with fresh water before starting ice production at initial installation
or after long shut-off periods.