Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12
11
18. Screw two mounting rails 7 with four
screws each10, four washers each and
11 four nuts 12 in such a way that the
exhaust hood will later hang at the cor-
rect height.
Please note! The bracket for the mount-
ing rails on top of the motor housing are
approx. 28 cm above the lower edge of
the exhaust hood. Therefore, deduct 28
cm from the ceiling to the desired lower
edge height of the exhaust hood.
9
19. As shown, screw the assembled mount-
ing rails 10 to the mounting rail bracket 9
with four screws 7, four washers 11 and
four nuts 12.
7
10
6
25
20. Only for exhaust air operation: Attach
21. As shown, screw the assembled mount-
2
7
10
22. Screw the base plate 2 with two screws
11
12
Assembly
the exhaust air hose 6 opening with a
diameter of 153 mm (see marking on the
hose) to the vent opening on the motor
housing in the exhaust hood 1 and se-
cure it with cable ties 25.
7
9
ing rails 10 and mounting rail bracket 1
with two screws 7 to the motor housing
on the exhaust hood 9.
12
11
10, two washers11 and two nuts 12 to
the mounting rails 7.
Page EN-19
10
10
7
Werbung
Kapitel
Inhaltsverzeichnis
