Pronomic OLS-5 BK Bedienungsanleitung Seite 8

Connections
Connect speaker wire (recommended 14-16 gauge) from the speaker output of the amplifier being used to the speaker
Connectors found on the backside of the speaker. Pay careful attention to polarity markings, Red = Positive, Black =
Negative. Damage may occur if polarity has been reversed or improperly wired.
For Speaker without Transformer
For Speaker with Transformer
NOTE: The total number of speakers multiplied by the tap value cannot exceed the output power (in watts) of the
70V/100V amplifier. The above example shows 5 total speakers. Using the 16W taps, you will need an amplifier with at
least (5)x(16)=80W. A good rule of thumb is to select an amplifier with 20% greater power; in this case, an amplifier that
delivers about 100W.