Herunterladen Inhalt Inhalt Diese Seite drucken

Possible Cause; Scrapping - Nilfisk BR 752C Bedienungshandbuch

Vorschau ausblenden Andere Handbücher für BR 752C:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ENGLISH
TROUBLE
The dirty water vacuuming is insufficient.
The solution flow is insufficient.
The squeegee leaves marks on the floor.
NOTE
If the machine has a battery charger installed, the machine cannot operate if the charger is not on board. In case of
battery charger malfunction, contact an authorised Service Center.
For further information, contact Nilfisk Service Centers.

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
Batteries
Brushes
Plastic hoses and components
Electrical and electronic components (*)
(*)
Refer to the nearest Nilfisk Center especially when scrapping electrical and electronic components.
Machine material composition and recyclability
Type
Aluminium
Electric motors - various
Ferrous materials
Wiring harness
Liquids
Plastic - non-recyclable material
Plastic - recyclable material
Polyethylene
Rubber
30
INSTRUCTIONS FOR USE
The recovery tank is full.
The vacuum grid is clogged or the float is
stuck closed.
Debris collection filter container clogged.
The hose is disconnected from the squeegee. Connect.
The squeegee is dirty or the squeegee blades
are worn or damaged.
The tank cover is not properly closed, or the
gasket is damaged.
Empty detergent solution tank.
The solution filter is dirty.
Dirty/encrusted EcoFlex system tank
(optional).
There is debris under the squeegee blades.
The squeegee blades are worn, chipped or
torn.
The squeegee has not been balanced with the
handwheel.
BR 652, BR 752, BR 752C - 9098684000

POSSIBLE CAUSE

Recyclable
percentage
100 %
29 %
100 %
80 %
100 %
0 %
100 %
92 %
20 %
revised 03/2018
REMEDY
Empty the tank.
Clean the vacuum grid.
Clean.
Clean the squeegee or overturn/replace the
blades.
Correctly close the cover or clean/replace the
gasket.
Fill.
Clean the filter.
Clean with the drain cycle.
Remove the debris.
Overturn or replace the blades.
Adjust the squeegee.
Machine weight percentage
9 %
18 %
42 %
3 %
0 %
3 %
1 %
23 %
1 %
12/2010

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis