Axis M1011 Installationsanleitung Seite 13

AXIS M1011/M1011-W/M1031-W Installation Guide
WEP
Authentication - Select Open or Shared Key, depending on the method used by your access
point. Not all access points have this option, in which case they probably use Open System,
which is sometimes known as SSID Authentication.
Key length - This sets the length of the key used for the wireless encryption, 64 or 128 bit. The
encryption key length may also be shown as 40/64 and 104/128.
Key type - The available key types depend on the selected access point. The following options
are available in the camera:
• Manual - Allows you to manually enter the hex key.
• ASCII - The string must be exactly 5 characters for 64-bit WEP and 13 characters for 128-
bit WEP.
• Passphrase - In 64-bit WEP, the Passphrase generates 4 different keys. For 128-bit WEP,
only 1 key is generated, which is then replicated for all 4 keys. Key generation is not stan-
dardized and can differ from brand to brand. Check that the generated keys are identical to
those in your access point - if not, they must be entered manually.
Complete the wireless installation
1. Check that the wireless settings in the camera correspond to the settings in the access point.
2. Disconnect the network cable from the camera.
3. Refresh the web page after 20-30 seconds to confirm the wireless connection. If the camera
cannot be accessed, run AXIS IP Utility and select it from the list.
Note:
• To establish communication, the wireless settings must be exactly the same in the camera as in the
access point or ad-hoc device.
• Keys, passphrases and certificates that are used for security must be entered manually. Contact your
Network Administrator for the requirements for the selected access point or ad-hoc device.
• Wireless settings must always (during installation and at all other times) be configured or changed in
the camera first, before changing the settings in the wireless access point. This ensures that the
camera is always accessible when making changes.
• SSID (Service Set Identifier) is sometimes written as ESSID (Extended Service Set Identifier).
AXIS M1011-W/M1031-W: The installation is now complete.
Page 13