Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
No.
Element
1
Audioplayer
2
Memory card slot
3
USB port
4
Infrared sensor for the
remote control
5
Remote control
6
Level control
7
Level control
8
Intensity control
9
Level control
10
Master control
11
Clip indicator
12
Power indicator
13
Microphone inputs
14
Line input
15
Line output
16
Tone control
17
Level controls
18
On/off switch
19
12V EXT. POWER
INPUT terminals
20
Battery indicators
21
Antenna inputs
22
Fuse holder
23
Power switch
Function
MP3 player with built-in Bluetooth receiver and 6 operating buttons.
[MODE]: Short actuation: for switching between USB, SD and Bluetooth
operation. / Long actuation: for switching the player on/off.
[►II]: For switching between play and pause.
[ ]: Stops the playback.
[
]: For selecting random play and repeat functions.
[ ] and [ ]: For title selection (short actuation) and fast forward/reverse
(long actuation).
For inserting an SD(HC) card.
For connecting a USB storage device.
When actuating a button, always direct the remote control towards the
sensor. There must be no obstacles between remote control and the
sensor.
[ ]:
For switching the audio player on/off.
[STOP]: Stops the playback.
[ ]:
For muting the audio player.
[MODE]: For switching between USB, SD and Bluetooth operation.
[ ]: For selecting random play and repeat functions.
[EQ]: For selecting equalizer settings.
[ ] and [ ]: For title selection.
[
] and [
]: For basic volume adjustment of the audio player.
[0-9]: Numerical keys for direct selection of a title.
To mix the microphone signals of the inputs MIC 1 and MIC 2 to the
master signal.
To mix the line signal to the master signal.
Adjusts the intensity of the internal reverb effect applied to inputs MIC 1
and MIC 2 and the wireless microphones.
To mix the audio player signal to the master signal.
Adjusts the overall volume.
Lights if the internal power amplifier section is overloaded. Reduce the
volume of the signal sources accordingly.
Lights when the PA system is powered on.
6.3 mm jacks for connecting microphones.
Stereo input (RCA L/R) for connecting audio units with line level (e.g. CD
player).
RCA jacks to feed the mixed signal (mono) to units with line level inputs,
e.g. another PA system.
Graphical 5-band equalizer for the master signal.
To mix the wireless microphone signals to the master signal. The LEDs
light when a radio signal is received.
Switches the receiver module on (POWER indicator lights) and off.
For alternative power supply from a 12 V source.
Indicate the status for the rechargeable battery. If only the red indicator
lights up, the battery should be charged.
BNC jacks for connecting the receiving antennas.
For the external power source and the rech. battery. Only replace the
fuse when the device is disconnected from mains. Only use fuses of the
same rating and power. The correct fuse value is specified on the rear
panel.
Switches the PA system on and off.
19 • EN
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
