Parkside PDBNP 14 A1 Originalbetriebsanleitung Seite 44

♦ Using both assembly spanners,
of the metal cone from the back piece (E2, E1). This gives you
access to the following parts:
A B C D
A Appliance shaft
B Lock nut
C Lock washer
D Spring
E1 Back piece of the metal cone
F Expanding mandrel
G Gripper jaws
E2 Front piece of the metal cone
♦ Remove the expanding mandrel (F) and the worn gripper jaws (G)
from the front piece of the metal cone (E2).
♦ Place the new gripper jaws (G) into the front piece of the metal
cone (E2) such that the narrow ends protrude from its opening.
NOTE
Both gripper jaws (G) must protrude from the opening flush with
each other. We recommend that you hold the front piece of the met-
al cone (E2) vertically, with the gripper jaws (G) pointing downward.
♦ Insert the expanding mandrel (F) such that its tips are inside the
notch formed by the rear ends of the gripper jaws (G).
♦ Using both assembly spanners,
screw the front and back piece of the metal cone (E2, E1) together.
♦ Screw the metal cone (E) back onto the appliance shaft (A) and
tighten it using the assembly spanner
to lock the lock nut (B).
PDBNP 14 A1
E1 F
and , unscrew the front piece
G E2
and ,
. Use the assembly spanner
GB │ IE │
41 ■