Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2
Only use the correct type of carbon
brushes.
● Remove the carbon brush holders (9) using
a screwdriver.
● Clean the carbon brushes.
● In case of wear, replace both carbon brushes
at the same time.
● Mount the carbon brush holders (9) using
a screwdriver.
● After mounting the new carbon brushes, let the
machine run at no load for 15 minutes.
wARRANty
Consult the enclosed warranty terms.
ENVIRONMENt
Disposal
8
The product, the accessories, and the packaging
must be sorted for environmentally friendly
recycling.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2002/96/EC
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
DECLARAtION Of CONfORMIty
Ferm B.V. declares under its sole responsibility
that this product (AGM1029) is in conformity with
the following standards and directives:
EN 60745-1, EN 60745-2-3, EN 55014-1,
EN 55014-2, EN 61000-3-2, EN 61000-3-3,
2006/42/EC, 2002/95/EC, 2002/96/EC,
2004/108/EC, 2006/95/EC
Zwolle, 01-01-2010
J.A. Bakker-van Ingen
CEO Ferm BV
Ferm BV
Lingenstraat 6
8028 PM Zwolle
The Netherlands
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
9
Werbung
Inhaltsverzeichnis
