Finding The Print Server In The Network; Installing And Starting The Intercon-Nettool - SEH PS105 Schnellstartanleitung

 Finding the Print Server in the Network
Once the print server is connected to the network, it checks whether an IP
address can be obtained from the boot protocols BOOTP or DHCP. If this is not
the case, the print server assigns itself an IP address via ZeroConf from the
address range (169.254.0.0/16) which is reserved for ZeroConf.
The 'InterCon-NetTool' has been developed by SEH Computertechnik GmbH for
the administration of SEH print servers. By means of this tool you can find the
print server's IP address and, if necessary, assign a suitable IP address to the print
server, as described below.


'Installing and starting the InterCon-NetTool'


'Finding the Print Server (Determining the IP Address)'

'Changing the IP address'
The client, printer and print server must be assigned to the same local network
segment.
Installing and starting the InterCon-NetTool
Proceed as follows:
1. Download the installation file for the InterCon-NetTool from the homepage
of the SEH Computertechnik GmbH:
http://www.seh-technology.com/services/downloads/
2. Start the InterCon-NetTool installation file.
3. Select the desired language.
4. Follow the installation routine.
The InterCon-NetTool will be installed on your client.
5. Start the InterCon-NetTool on your client.

After the InterCon-NetTool was started, it searches the network for existing
devices and displays them in the 'device list'.
12

13
download-printserver-extern/ps105.html
[en]

12

13
Quick Installation Guide