Assembling/Dismantling The Two-Piece Suction Tube; Installing/Removing The Collection Bag - FLORABEST FLS 3000 B2 Originalbetriebsanleitung

G B M T
2. Now push the blow tube (9) on
to the blowing aperture of the
motor housing (1) as far as the
locking device (8).
3. Place the protective cover of the
suction opening (7) on the under-
side of the motor housing. Turn
the protective cover clockwise as
far as it will go.
4. Attach the protective cover by ti-
ghtening the screw with star grip
(18) in the holder.
The screw with star grip has to be
tightened as far as it will go by
hand, as otherwise the leaf blower
cannot be started later.
5. Dismantle the blow tube (9) by
releasing the lock (8) and pulling
off the blow tube forwards.
Assembling/dismantling the
two-piece suction tube
Never use the leaf vacuum
with only one suction tube
section attached. There is a
risk of personal injury!
After the two-part suction
tube has been assembled, it
must not be divided up again
into two parts!
1. Remove the protective cover of
the suction opening by unscrew-
ing the screw with star grip (18)
and turning the protective cover
anti-clockwise and removing it.
2. Assemble the two suction tubes
(16) as illustrated. The parts can
be felt to lock into place.
4 8
3. Place the suction tube (16) on
4. Attach the suction tube by tighte-
The screw with star grip has to be
tightened as far as it will go by
hand, as otherwise the leaf vacuum
cannot be started later.
5. Dismantle the suction tube (16)
Installing/removing the
collection bag
In suction mode the device can only
be operated with the collection bag
installed.
The ventilation opening on the collection bag
( 20) serves for an improved air circulation.
A B C D E
K L M N O
1. If necessary, remove the blower
U V W X Y
2. Push the catcher (14) on to
3. Hang the fastening hook (15) of
During assembly, make sure that
the groove on the upper section
of the suction tube is inserted
into the recess provided on the
lower section of the suction tube.
the underside of the motor hou-
sing (1). Turn the suction tube
clockwise as far as it will go.
ning the screw with star grip
(13) in the holder.
by releasing the screw with star
grip (13) und turning the suction
tube anti-clockwise.
F G H I
P Q R S
tube ( A 9) (see „Assembling/dis- B C
Z
mantling the two-piece blow tube").
K L M
the blower outlet of the motor
U V W
housing (1) until this snaps into
place in the locking device (8).
the collection bag (14) on the
holding points (19) provided on
the suction tube.
J
T
D E F G
N O P Q
X Y Z
H I
R S