Electrical Connection Devicenet; Start-Up; Safety Instructions; Starting-Up Type 8792 - bürkert 8792 Bedienungsanleitung

15.5 Electrical connection DeviceNet
To operate the appliance, the following must be connected:
→
X1 - circular connector M12, 8-pole
(operating voltage see "Tab. 18") and
→
X3 - circular connector M12, 5-pole
(DeviceNet see "Tab. 23").
15.5.1 X3 - M12, 5-pole circular connector -
bus connection
Pin Signal Colour
1 Shielding not used
2 V+ not used
3 V– not used
4 CAN H white
5 CAN L blue
Tab. 23: Pin assignment DeviceNet; X3 - M12, 5-pole circular connector -
bus connection
When the operating voltage is applied, Type 8792/8793 is
activated.
→
Now make the required basic settings:
Positioner:
see "16.2.1 Specifying the standard settings"
Process controller:
see "16.3.1 Basic settings of the process controller"
42
Configuration
4
1
english

16 START-UP

16.1 Safety instructions
WARNING!
Risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the
device and the area around it.
▶ Before start-up, ensure that the operating personnel are familiar
with and completely understand the contents of the operating
instructions.
▶ Observe the safety instructions and intended use.
▶ Only adequately trained personnel may operate the equipment/
3
the device.
5
16.2 Starting-up Type 8792
2
16.2.1 Specifying the standard settings
The basic settings are made on the setting level.
To change from the process to the setting level, press the
MENU key for approx. 3 seconds.
You must make the following basic settings for starting up:
• Setting the input signal (INPUT)
• Automatic adjustment of the positioner (X.TUNE)
Type 8792, 8793
Start-Up