Starting Up Nvr; Nvr Channel Configuration By Manual Assignment - urmet NVR Boost 3.0 Serie Kurzanleitung

EN
For NVR Installation follow these step:
• Connect the mouse to the USB port
• Connect the HDMI Output
• Connect the network cable to the port
Only for HP Series: Connect one or more IP PoE Cameras with straight Cat. 5 cable to one or more ports
• Switch on the device inserting the power connectors inside the plugs
position 1.

Starting up NVR

NVR CHANNEL CONFIGURATION BY MANUAL ASSIGNMENT

Here follow the step in order to add IP cameras to NVR channels using local Monitor:
1. Access the NVR OSD menu by pressing the right mouse button and enter the administrator password (default:
00000000), to check the firmware version that is currently installed in the NVR, access the menu page
"System" -> "Info". If the version is not recent, the NVR system software (firmware) can be updated by following
the instructions described in User Manual available in Urmet Web site (see QR code printed on the Addendum
sheet).
• In the page "Main Menu" -> "Parameter" -> "Network" display the NVR current network parameters: wait about
ten seconds for assignment and automatic display of network parameters.
DS1093-502
1
.
3
2
or VGA Output to the monitor used for the configuration of the IP cameras.
4
.
22
5
and position the switches
7
6
on