Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Please note that the battery life of the watch depends on the frequency with
which notifications appear: the more notifications there are, the less battery life
the watch will have.
18. BATTERY CHARGING STATUS (
BAT
At any time, the BAT function shows the status of the battery charge in percentage,
by indicating
xx
on the upper screen. Charging is recommended when the
BAT
%
charge is less than 30-25%. When the battery reaches this level, the seconds hand
advances in 4-second increments.
a)
mode
DEEP SLEEP
mode allows the battery to be disconnected from the watch's electronic
DEEP SLEEP
circuits and thus to preserve its performance (capacity). This function is useful if the
watch is not used over a relatively long period. This operation also enables a reset
of the watch. The manual sleep mode setting procedure is as follows:
• Select the
function by turning the crown.
BATTERy
• Pull the crown into position 2. The upper screen displays
. Select
by turning the crown.
SLEEP
DEEP SLEEP
• Give P1 a long press to confirm the extended standby. The hands "park"
immediately. Once the procedure is finished, the display turns off and the
electronics are disconnected. Following this, the pushpieces and crown are
completely inactive.
xx
)
%
DEEP SLEEP
132
• Do not forget to push the crown back into neutral position 1.
To reactivate the watch, it must be charged using the cable supplied, and a com-
plete reinitialization must be performed, as described in chapter 3.
b)
SOFT SLEEP
The
SOFT SLEEP
equivalent to the mode adopted by the watch when the remaining battery life is
too low (level 3 – chapter 2.b). This function is useful in the event of the watch not
being used for a short time and when one wishes to maintain a maximum of the
battery life as well as the settings and the correct time. The setting procedure for
the active standby state is as follows:
•
Select the
•
Pull the crown into position 2. The upper screen will display
. Select
SLEEP
•
Give P2 a long press to confirm standby mode. The hands will "park". Once the
procedure is terminated, the display turns off but the basic time of the watch
or
SOFT
remains active. At this point, the pushpieces and crown are completely inactive.
•
Do not forget to push the crown back to neutral position 1.
In order to reactivate the watch, it must be charged using the cable provided.
mode
mode allows the watch to be put in a state of active standby,
function by turning the crown.
BATTERy
by turning the crown.
SOFT SLEEP
133
or
DEEP SLEEP
SOFT
Werbung
Inhaltsverzeichnis
