BH FITNESS G247N Montage- Und Gebrauchsanleitung Seite 14

(140) Covers main post.
(118) 2 Focus bar spindle covers (L).
(119) 2 Focus bar spindle covers (R).
(138) Transformer, 9V .
(145) Monitor. Mod. G-246
(151) Monitor. Mod. G-247N
Fig.2 Screws and fasteners
(57) Allen screws M-8x90.
(55) Self locking nuts M8.
(56) Washers M8 Ø 16.
(61) Screws M-3x40.
(A) Combination box spanners.
(B) Allen key.
2. FITTING THE MAIN POST.-
Mod. G-246.-
Take the main post (11) and remove
the screws (13)
washers (14) and spring washers (16)
from the bottom of the post. Fig.3.
Next, bring the main post (11) up to
boss (D) on the main body (5), Fig.3,
connect the terminals (103) and (15),
Fig.3A.
Slip the main post (11) over the boss
(D) on the main body (5) in the
direction of the arrow, Fig.3, making
sure not to snag any of the cables.
Refit the screws (13), the washers
(14) and the spring washers (16) that
you removed previously, and tighten
securely.
Mod. G-247N.-
Take the main post (11) and remove
the screws (13)
washers (14) and spring washers (16)
from the bottom of the post. Fig.4.
Next, bring the main post (11) up to
boss (D) on the main body (5), Fig.4,
connect the terminals (106 with 110)
and (108 with 20), Fig.4.
Slip the main post (11) over the boss
(D) on the main body (5) in the
the corrugated
the corrugated
direction of the arrow, Fig.4, making
sure not to snag any of the cables.
Refit the screws (13), the washers
(14) and the spring washers (16) that
you removed previously, and tighten
securely.
3. FITTING THE FOOT BARS.-
Take the left foot bar (32) and position
it on the "U" at the bottom of the left
focus bar (21), Fig.5.
Insert screw (57), as shown in Fig.5A,
then fit the flat washer (56) and the
self locking nut (55), and tighten
securely.
Take the right foot bar (33) and go
through the same assembly procedure
as with the left.
4. FITTING THE FOCUS BAR SIDE
COVERS TO THE FOOT BARS.-
Take the covers (118R and 119R),
marked on the inside with the letter
"R", and position them at the end of
the foot bars with the inside of the
focus bars on the right hand side, as
shown in Fig.6. Now use screws (27)
to attach them. Use screws (61) to
screw them together.
Carry out the same procedure using
the covers (118L and 119L) marked
on the inside with the letter "L".
Next, release the screws (27 and 139)
of the main post (11), take bottle
holder (140), and insert it in through
the top of the post (11) in the direction
of the arrow. Attach the bottle holder
using screws (27 and 139) previously
removed.
14