Klarstein Ice Volcano 2G Bedienungsanleitung Seite 24

EN
24
TROUBLESHOOTING
Problem
symbol is lightening on
and the arrow flashes.
symbol is lightening
and letter "F" flashes.
Errorcode
Errorcode
Ice cubes on the evapora-
tor stick together.
Possible Cause
Lack of Water.
There is too much ice.
No ice cube inside.
Ambient temperature
sensor breakdown
The ice-making box can
not reset normally.
The ice cycle is too long.
Water temperature in inner
tank is too low.
Solution
Stop the ice maker, fill
water, and press "ON/
OFF" button again to
restart the unit.
Suggest you to obtain the
ice-cube.
Remove the probable
obstacle inside or clean
the inside wall of the ice
storage, if still can't start
to ice making process,
press "SELECT" for more
than 5 seconds to run the
ice making for 10 cycles
at most.
The unit can still work,
but suggest to call the
manufacturer service man
or electrical technician to
change to a new sensor.
Call the manufacturer
service man or qualified
technician to check the
problem.
Stop the ice maker,
and restart it after the
ice blocks melt. Select
the small size ice cube
selection.
Change the water in the
inner Tank. Temperature of
water is better set between
7 -32 .