Axis M1145 Serie Installationshandbuch Seite 12

AXIS M1145 Series
Note
• The Status LED can be configured to be unlit during normal
operation. To configure, go to Setup > System Options > Ports
& Devices > LED. See the online help for more information.
• The Status LED can be configured to flash while an event is
active.
• The Status LED can be configured to flash for identifying the
unit. Go to Setup > System Options > Maintenance .
• The Power LED can be configured to be unlit during normal
operation. To configure, go to Setup > System Options > Ports
& Devices > LED. See the online help for more information.
• The Network LED can be disabled so that it does not flash when
there is network traffic. To configure, go to Setup > System
Options > Ports & Devices > LED. See the online help for more
information.
Connectors and Buttons
For specifications and operating conditions, see page 14.
Network Connector
RJ45 Ethernet connector. With Power over Ethernet (PoE).
NOTICE
NOTICE NOTICE
Due to local regulations or the environmental and electrical
conditions in which the product is to be used, a shielded network
cable (STP) may be appropriate or required. All cables connecting
the product to the network and that are routed outdoors or in
demanding electrical environments shall be intended for their
specific use. Make sure that the network devices are installed in
accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic Compatibility
(EMC), on page 2.
12