General Information; Warranty; Product Description - bürkert 8605 Schnellstartanleitung

5.

GENERAL INFORMATION

5.1. Contact address
Germany
Bürkert Fluid Control �ystems
�ales Center
Chr.�Bürkert��tr. 13�17
D�74653 Ingelfingen
Tel. + 49 (0) 7940 � 10 91 111
Fax + 49 (0) 7940 � 10 91 448
E�mail: info@de.buerkert.com
International
Contact addresses can be found on the final pages of the
printed operating instructions.
And also on the Internet at: www.burkert.com

5.2. Warranty

The warranty is only valid if the device is used as authorized
in accordance with the specified application conditions.
5.3. Information on the Internet
Operating instructions and data sheet for Type 8605 can be
found on the Internet at:
www.burkert.com
english
8
6.3. Forms of the device
6.3.1. Type 8605 Cable plug version
Fig. 1: Type 8605 Cable plug version
Plug�in version on valves with connector pattern A (e. g. types
2832, 2833, 2834, 2835, 2836, 2853, 2863, 2865, 2873,
2875, 6022, 6023, 6024, 6223).
The operating unit can be removed after the setting process.
During operation of the Control Electronics 8605 in cable
plug version without operating unit, the operating status is
indicated by two LEDs.
Device variants:
• Variant 1 for valves with a max. current from
200 to 1000 mA
• Variant 2 for valves with a max. current from
500 to 2000 mA
english
10
6.

PRODUCT DESCRIPTION

6.1. Field of Application
The Control Electronics, Type 8605, is designed for con�
tinuous operation in industrial environments, in particular in
the fields of open�loop and closed�loop control engineering.
6.2. General Description
The Digital Control Electronics for Proportional Valves, Type
8605 (hereinafter referred to as Control Electronics, Type
8605) Controls all Bürkert proportional valves with a max.
current in the range from 40 to 2000 mA.
It transforms an external standard signal into a pulse�width
modulated voltage signal (PWM) that is supplied to the
solenoid coil of the proportional valve.
A given value of the average coil current is thereby assigned
to each value of the input signal. The proportional opening
of the valve can be set via the coil current.
6.3.2. Type 8605 DIN rail version
Fig. 2: Type 8605 DIN rail version
�eparate electronics in housing for DIN rail mounting to DIN
EN 50022. This form is suitable for all proportional valves in
the indicated current range. The operating unit cannot be
removed.
Device variants:
• Variant 1 for valves with a max. current from
40 to 220 mA
• Variant 2 for valves with a max. current from
200 to 1000 mA
• Variant 3 for valves with a max. current from
500 to 2000 mA
Type 8605
english
9
english
11