Husqvarna FS 500 E Bedienungsanweisung Seite 11

4. Loosen the front nut and tilt the blade guard to the
servicing position.
5. Remove the blade screw (A).
B
A
6. Remove the blade flange (B).
7. Examine the blade screw (A), the blade flange (B)
and the inner flange (C) for damages. Replace worn
or damaged parts.
8. Clean the contact surfaces of the cutting blade and
the flanges.
9. Install the cutting blade on the inner flange (C).
1024 - 001 - 04.06.2019
D
C
10. Make sure that the cutting blade rotates in the
direction of the arrows shown on the cutting blade.
CAUTION: Risk of damage to the cutting
blade if it is installed opposite the
direction of rotation.
11. Install the blade flange (B) and the blade shaft bolt
(A). Make sure that the locking pin (D) on the inner
flange, goes through the cutting blade and into the
blade flange (B).
12. Hold the cutting blade tightly, while you tighten the
screw (A) with the supplied wrench.
13. Turn the cutting depth wheel clockwise to lower the
cutting blade.
14. Tighten the screw (A) fully with the supplied wrench.
The resistance between the cutting blade and the
ground keeps the cutting blade in position.
15. Install the blade guard and attach the water hose.
16. Start the product and listen for unusual sounds. If
there are unusual sounds, remove the cutting blade.
a) Examine the cutting blade for damages.
b) Install the cutting blade again. Replace the
cutting blade if it is damaged.
To remove the cutting blade
WARNING: When you remove diamond
blades, let the product become cool and use
protective gloves. Diamond blades are very
hot after use.
• Remove the cutting blade in the opposite sequence
of how it was installed. Refer to
blade on page 10 .
To set the cut depth indicator
The indicator must be calibrated before you use the
product.
To install the cutting
11