SOLIS PERSONAL BARISTA Typ 1150 Bedienungsanleitung Seite 62

6. Carefully disassemble the brewing group and make sure that the spring and the
metal pin are not lost.
GB
7. Clean all parts of the brewing head and the gasket with the included cleaning
brush (28). If necessary, replace the sealing ring with the included replacement
sealing ring (24).
8. Reassemble all parts and carefully tighten the screw with a coin or a screwdriver.
C L E ANI NG T HE CHA SSIS, TH E CUP SHEL F AN D T H E BEAN
■
C ON TAI NE R
The appliance has to be switched off and disconnected from the power mains
before the chassis is cleaned.
Clean the chassis, the cup shelf and the bean container with its lid with a soft, only
slightly moist towel before drying it with a dry towel.
In general, do not use any abrasive or aggressive cleaning agents, rough
sponges or cloths, as they might scratch the surface.
122
CL EA NIN G T HE DR IP TRA Y WI TH D RI P G RI D
■
Before the drip grid and the drip tray are cleaned, the appliance has to be
switched off and disconnected from the power mains.
Remove, empty and clean the drip tray with drip grid regularly and every time it
●
is full.
1. Remove the drip grid and pull the drip tray out to the front. Hand wash the drip
tray and the drip grid with warm dishwater. Do not use any aggressive cleaning
agents or scouring sponges. Rinse the tray and the grid with clear water and
carefully dry both parts.
CAUTION: Drip tray and drip grid are not dishwasher safe.
2. Reinsert the drip tray and place the grid back on the drip tray.
STO RING THE SO LIS PERSO NA L B AR ISTA
■
ESPRESSO MAC HI NE
Swivel the steam / hot water wand to its original position and switch the appliance
off with the ON/OFF button. Disconnect the power plug from the power socket and
the connection plug from the appliance socket.
Store the cooled down, cleaned and dry machine in an upright position, ideally in
the original packaging. Do not place any items on the appliance.
GB
123