P
RECAUTIONS
•
Do not charge the transceiver and battery pack when they are wet.
•
Ensure that there are no metallic items located between the
transceiver and the battery pack.
•
Do not use options not specified by KENWOOD.
•
If the die-cast chassis or other transceiver part is damaged, do not
touch the damaged parts.
•
If a headset or headphone is connected to the transceiver, reduce
the transceiver volume. Pay attention to the volume level when
turning the squelch off.
•
Do not place the microphone cable around your neck while near
machinery that may catch the cable.
•
Do not place the transceiver on unstable surfaces.
•
Ensure that the end of the antenna does not touch your eyes.
•
When the transceiver is used for transmission for many hours, the
radiator and chassis will become hot. Do not touch these locations
when replacing the battery pack.
•
Do not immerse the transceiver in water.
Turn the transceiver power off in the following locations:
•
In explosive atmospheres (inflammable gas, dust particles,
metallic powders, grain powders, etc.).
•
While taking on fuel or while parked at gasoline service stations.
•
Near explosives or blasting sites.
•
In aircrafts. (Any use of the transceiver must follow the
instructions and regulations provided by the airline crew.)
•
Where restrictions or warnings are posted regarding the use of
radio devices, including but not limited to medical facilities.
•
Near persons using pacemakers.
i