Loading Paper - Sony UP-895 Gebrauchsanweisung

Loading Paper

Loading Paper
Notes
• Before loading paper, read "Paper" on page 25.
• Do not fold the paper or touch the printing surface.
Dust or finger prints are likely to cause poor print
quality.
• Use only UPP-110S/110HD/110HG paper as specified
for this printer. (page 25)
• Set the PAPER TYPE switch according to the paper
type. (page 23)
Loading
1
Press the power switch to turn on the printer.
The power lamp lights.
2
Press the OPEN button to open the door.
3
Remove the label attached at the top of the paper
roll, pull out the first 15 to 20 cm (6 to 8 inches) of
the paper, then place the paper roll in the paper
tray.
Note
When pulling out the top of the paper roll or placing
it in the paper tray, be careful not to drop the paper
roll. If dust has accumulated on the paper, you may
not be able to use this paper because dust or finger
prints are likely to cause poor print quality or
malfunction of the head.
26
Preparation
Place the paper with the thermo-sensitive
side (printing side) up. If you place the paper
with the printing side down by mistake, the
image will not be printed.
4
Close the door by pushing it.
Note
• If the paper roll is not placed properly and does not
come out from the paper tray straight, this may cause
paper jamming.
• If you did not pull out the paper enough in step 3, feed
the paper at least 15 to 20 cm by pressing and holding
down the FEED button. Do not pull out the paper
manually.
Remove the label and pull out the
first 15 to 20 cm (6 to 8 inches) of
the paper.
Place the paper roll so
that the paper comes
out from the paper tray
straight.