Guarantee; Fault Finding - Grizzly ERT 350 Bedienungsanleitung

• Do not store the trimmer for a long period
in direct sunlight.
• Do not cover the device with plastic bags,
since this could generate humidity and
mold.
• Do not place the device on the protective
cover. The best thing is to suspend it
from the upper handle so that the protec-
tive cover does not come in contact with
any other objects. The danger exists oth-
erwise that the protective cover will de-
form and dimensions and safety features
will thus change.

Guarantee

We provide a 24 month guarantee for this de-
vice. The guarantee period for appliances
used commercially and exchange appliances
is shorter. Damages, which can be attributed
to natural wear, overloading or inappropriate
use, are excluded from the guarantee. Cer-
tain component parts are subject to normal
wear and are excluded from the guarantee.
In particular, these include line spool, cutting

Fault Finding

Problem
Device vibrates
Device does not start
Inferior cutting performance
line and carbon brushes, provided that the
complaints cannot be attributed to flaws in
the materials themselves. Furthermore, a
condition of the guarantee services is that
the maintenance intervals, indicated in the
operating instruction, have been adhered to
and the instructions on the cleaning, care
and maintenance have been followed. Dam-
ages, which originate due to material or
manufacturer faults, will be repaired free of
charge by replacement delivery or repair.
This is subject to the condition that the de-
vice is not disassembled and has been given
back to the dealer with purchase and guaran-
tee verification
You can have repairs done, which are not
subject to guarantee, for a charge by our
Service Center. Our Service Center will be
glad to give you a cost estimate. We can
process only those devices, which have been
packed adequately and sent in properly
stamped.
Caution: Possible material damages during
transport are borne at the expense of the
sender.
Possible cause
Spool soiled
Spool defective
Mains voltage not applied
On/Off switch defective
Worn carbon brushes
Defective motor
Thread spool does not have
sufficient line
Thread is not guided out of
spool or extends from the
spool on one side only
Fault correction
Clean spool (see chap. Maintenance
and cleaning)
Replace spool (see chap. on
Maintenance and cleaning)
Check plug socket, cable, line and
plug, where appropriate, have
repaired through electrical specialist
Repair through customer service
Adjust nylon line (see chap. on
operating the lawn trimmer)
Replace spool (see chap. on
Maintenance and cleaning)
Remove spool and thread line through
the openings to outside, mount spool
again.
GB
43 43