IKRA Mogatec IEH 2500 Gebrauchsanweisung Seite 17

IMPORTANT
READ CAREFULLY BEFORE USE
KEEP FOR FUTURE REFERENCE
Safe operating practices
Training
Become familiar with the owner's manual before
attempting to operate this equipment.
Preparation
1) Do not allow children to operate this equip-
ment;
2) Do not operate this equipment in the vicinity
of bystanders;
3) Do not connect a damaged cord to the supply
or touch a damaged cord before it is discon-
nected from supply. A damaged cord can lead
to be contacted with live parts.
4) Wear ear protection and safety glasses at all
times while operating the machine;
5) Avoid wearing clothing that is loose fitting or
that has hanging cords or ties;
6) Only operate the machine in open space (e.g.
not close to a wall or other fixed object) and
on a firm, level surface.
7) Do not operate the machine on a paved or
gravel surface where ejected material could
cause injury;
8) Before starting the machine, check that all
screws, nuts, bolts, and other fasteners
are properly secured and that guards and
screens are in place. Replace damaged or
unreadable labels;
Operation
1) Before starting the machine, look into the
feeding chamber to make certain that it is
empty;
2) Keep your face and body away from the feed
intake opening;
3) Do not allow hands or any other part of the
body or clothing inside the feeding chamber,
discharge chute, or near any moving part;
4) Keep proper balance and footing at all times.
Do not overreach. Never stand at a higher
level than the base of the machine when
feeding material into it;
5) Always stand clear of the discharge zone
when operating this machines;
6) When feeding material into the machine be
extremely careful that pieces of metal, rocks,
GB | Operating Instructions
7) If the cutting mechanism strikes any foreign
8) Do not allow processed material to build up in
9) If the machine becomes clogged, shut-off the
10) Keep all guards and deflectors in place and in
11) Do not transport this machine while the power
12) Shut off the power source and disconnect
13) Do not tilt the machine while the power source
14) To keep extension cords away from the
15) If the supply cord is damaged, it must be re-
16) This appliance is not intended for use by per-
GB-2
bottles, cans or other foreign objects are not
included;
objects or if the machine should start making
any unusual noise or vibration, shut off the
power source and allow the machine to stop.
Disconnect from supply and take the follow-
ing steps:
• Inspect for damage;
• Check for and tighten any loose parts;
• Have any damaged parts replaced or re-
paired with parts having equivalent speci-
fications.
the discharge zone; this may prevent proper
discharge and can result in kickback of mate-
rial through the feed intake opening;
power source and disconnect from supply be-
fore clearing debris. Keep the power source
clear of debris and other accumulations to
prevent damage to the powered source or
possible fire. Remember that operating the
starting mechanism on engine powered ma-
chines will still cause the cutting means to
move;
good working condition;
source is running;
from supply whenever you leave the work
area;
is running.
shredding means. The shredding means can
cause damage to the cords and lead to con-
tact with live parts.
placed by the manufacturer, its service agent
or similarly qualified persons in order to avoid
a hazard.
sons (including children) with reduced physi-
cal, sensory or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety. Children should
be supervised to ensure that they do not play
with the appliance.