Specifications; Operation - Ryobi EHT150V Bedienungsanleitung

GB
FR DE ES IT
33. Grooved gripping section
34. Live tool indicator
35. Collet sleeve
36. Tool head

SPECIFICATIONS

Input 230 V - 240 V
Rated speed 10,000-35,000 (RPM) min
Collet 3.2 mm max.
Weight 0.73 kg

OPERATION

WARNING
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
suffi cient to infl ict serious injury.
WARNING
Always wear eye protection. Failure to do so could
result in objects being thrown into your eyes, resulting
in possible serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of the product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Cutting
Sanding

 Polishing and buffing
 Engraving
 Drilling
 Grinding
TURNING THE ROTARY TOOL ON/OFF
See Figure 2.
 To turn the tool on: Slide the switch to "|".
 To turn the tool off: Slide the switch to "O".
NL PT DK SE FI NO
English
50 Hz
-1
RU PL CZ HU RO LV
To prevent damage to the spindle or spindle lock,
always allow motor to come to a complete stop before
engaging the spindle lock.
CHANGING COLLETS
See Figure 3.
 Unplug the tool.
 Press and hold the spindle lock, and rotate the shaft
with the provided collet wrench until the spindle lock
engages the shaft, preventing further rotation.
 With the spindle lock engaged, use the collet wrench
to loosen the collet nut, if necessary.
 Remove the collet nut and old collet using collet
wrench, if necessary.
 Insert the unslotted end of the collet in the hole in the
end of the tool shaft.
 Replace the collet nut on the shaft.
Always use the collet which matches the shank size
of the accessory you plan to use. Never force a large
diameter shank into a collet. The accessory should
fi t smoothly into the collet, but you should be able to
tighten the accessory fi rmly and securely with the
provided wrench.
If you are changing an accessory immediately after
use, be careful not to touch the collet, collet nut, or
the accessory with your hands or fi ngers. You will
get burned because of the heat build-up from cutting.
Always use the wrench provided.
INSTALLING ACCESSORIES
See Figure 4–5.
 Unplug the tool.
 Press and hold the spindle lock, and rotate the shaft
by hand until the spindle lock engages the shaft,
preventing further rotation.
 With the spindle lock engaged, use the collet wrench
to loosen the collet nut, if necessary.
 Insert the shank of the accessory into the collet until
the shank bottoms out, then pull it out 1.6 mm (1/16 in)
to allow for expansion when the accessory gets hot.
 With the spindle lock engaged, tighten the collet nut
4
LT EE HR SI SK GR
CAUTION
WARNING
DANGER
TR