Cleaning And Storage - Velleman MB02C Bedienungsanleitung

Operation
6.
• Mount the LED sign on a wall or ceiling using the suspension hooks [A] and. Note that a
mains outlet is required at ±1.5m distance.
• Plug the DC plug of the included adaptor in the back of the LED sign (see illustration on
page 2 of this manual). Plug the power adaptor in the mains.
• The clock lights up. If this is not the case, press the on/off button
control. Aim the remote control at the front of the LED sign.
• To display the OPEN message, press the 'OPEN' button
• To display the CLOSED message, press the 'CLOSED' button
• To hide the message, press the 'HIDDEN' button
• The clock format is HH:MM:SS (24h format only).
• To set the time, press the clock button
• Use the left
• Use the up
• Press the 'ENTER' button
• The time will be memorized when the LED sign is switched off or the power adaptor is
unplugged.
• Note that the 'USER' button

Cleaning and storage

7.
• Wipe the exterior of the LED sign regularly with a moist, lint-free cloth. Do not use
abrasive solutions or solvents.
• There are no user-serviceable parts. Contact your dealer for spare parts if necessary.
Battery
8.
LED sign
• The LED-sign contains an internal battery CR2032 to maintain the clock in memory.
• To replace the battery, switch the LED sign off and unplug the adaptor from the mains.
• Loosen the 4 screws on the front of the LED sign and remove the cover.
• Gently take the battery out of the battery holder and place a new Lithium CR2032 battery in
the holder with the correct polarity.
• Place the cover back – verify that the clock and LED sign are fully visible – and screw the 4
screws back in place.
• Note that when the LED sign is end-of-life, the battery must be removed from the device.
remote control
• The remote control uses 1 battery type 3V lithium CR2025 battery (incl.)
• To (re)place the battery, press on the side of the battery cover [1] and
pull [2] to slide it open.
• Insert the battery with the right polarity and close the battery
compartment by pushing it back into the housing of the remote control
until it snaps into place.
general
• Do not recharge batteries and do not throw in fire as they may explode.
WARNING:
Handle Lithium batteries with care, keep batteries away from children.
All batteries MUST be removed when the device is end-of-life.
Dispose of batteries in accordance with local regulations.
00 (27/11/2008)
or right button to select the digit. Selected digit flashes.
or down button to change the digits value.
to save the set time and exit time set mode.
has no functionality.
MB02C
.
.
.
4
on the remote
.
®
Velleman