Operation - EuroLite 50603600 Bedienungsanleitung

The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
- - -m
The symbol determines the minimum distance from lighted objects. The minimum distance
between light-output and the illuminated surface must be more than 0.5 meters.
The housing must never touch surrounding surfaces or objects.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the
fixture.
The maximum ambient temperature T = 45° C must never be exceeded.
a
Operate the device only after having become familiarized with its functions. Do not permit operation by
persons not qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.
Attention: The operation of warning beacons in Germany is permitted only in non-public areas.
Use in whole public area (streets, roads, and plazas) is prohibited!
This prohibition applies also to areas immediately adjoining public traffic, since an endagering of
the traffic flow cannot be excluded!

OPERATION

Regarding the article numbers 50603600 or 50603605: Install the device on a plane surface.
Regarding the article number 50603620: Mount the item on the rear view mirror of the automobile with the
fastening belts. The desired flash mode can be selected via the function switch.
Connect the Strobe Police Beacon to the cigarette lighter with the plug and the lamp begins to flash.
9/10 00057249.DOC, Version 1.2