Zepter EdelWasser PWC-670-BLACK Handbuch Seite 7

EN
Installation of inlet tubing (orange)
ATTENTION
Plumbing and carpentering work is needed
Ensure, whether the main water supply is turned off before any
plumbing work is started.
POSSIBILITY 1
Precautions
1. Close the mains water supply valve to separate
the tap.
2. Apply the Teflon tape onto the adaptor and fit it
to the pipe.
Do not turn the water pipe.
3. Connect the tap to the adaptor.
Install the adaptor with connector
on the cold water pipe.
4. Connect 1/4 inch orange tubing with the connector
on the adaptor.
Flush water through each filter for
at least 5 minutes before connection.
5. Open the feed valve to supply water to the
filtration system.
POSSIBILITY 2
It can be use in case when the customer prefer installation of inlet tube under
the sink.
1. Close the main water supply.
2. Install the adaptor with connector on the cold
water pipe.
3. Connect the inlet tube (orange) with the
connector.
4. Plug orange inlet tube to the main device.
5. Open the feed valve to supply water to the filtration system.
Open valve
EN
Closed valve
11