Replacing Lamps; Troubleshooting; After-Sales Service - De Dietrich DHG1136X Montage- Und Gebrauchsanweisung

Replacing lamps -

Fig. 9
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down. Replace with a new 12 Volt, 20 Watt (Maximum)
Ø50mm halogen light made for a GU5.3 base SUITABLE
FOR USE IN OPEN LUMINAIRES. Follow package directions
and do not touch new light with bare hands.
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE). By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents
accompanying the product, indicates that this appliance may
not be treated as household waste. Instead it should be taken
to the appropriate collection point for the recycling of electrical
and electronic equipment. Disposal must be carried out in
accordance with local environmental regulations for waste
disposal. For further detailed information regarding the
process, collection and recycling of this product, please
contact the appropriate department of your local authorities or
the local department for household waste or the shop where
you purchased this product.

Troubleshooting

SYMPTOMS
The hood is not working... Ensure that:
The hood is not operating
effectively...
The hood stopped
working
SOLUTIONS
• The power is not cut off.
• A speed has been selected.
Ensure that:
• The selected motor speed is
sufficient for the quantity of
smoke and vapours to be
cleared.
• The kitchen is sufficiently
ventilated to allow for fresh
air intake.
• The air pipe circuit involves
a lack of efficiency of the
cooker hoods. Contact a
qualified technician.
• The carbon filter is not worn
(hood operating in recycling
mode).
Ensure that:
• The power is not cut off.
• The single-pole cut-off
device was not activated.

After-sales service

Any maintenance on your equipment should be undertaken
by:
- either your dealer,
- or another qualified mechanic who is an authorized agent for
the brand appliances.
When making an appointment, state the full reference of your
equipment (model, type and serialnumber).
This information appears on the manufacturer's nameplate
attached to your equipment.
55