Specifications - IMG STAGELINE TXS-890HT Bedienungsanleitung

5 Setting the Microphone into Operation
1) To switch on the microphone, set the switch
POWER (3) to "ON".
The display (8) indicates the transmission chan-
nel adjusted (b). It the battery symbol (a) is dis-
played after switching on or during operation, the
inserted batteries are almost exhausted and must
be replaced.
2) To remove the plastic cap (2), slightly press down
the grooved latch on the rear side of the cap and
remove the cap. This will allow access to the control
part with the two channel adjusting keys
[see fig. 4]. To actuate the keys, it is recommended
to use a narrow, pointed object, e. g. a small screw-
driver.
3) To adjust the transmission channel, press the key
or (7). On the display, the letters "CH" of the
channel indication (b) start flashing. As long as
"CH" keeps flashing, the channel can be select-
ed: When pressing the key
scanned in ascending order, when pressing the key
, they are scanned in descending order.
The 16 transmission channels are assigned to
the following transmission frequencies:
Channel Frequency
1 790.875 MHz
2 792.625 MHz
3 794.250 MHz
4 795.625 MHz
5 797.125 MHz
6 798.875 MHz
7 801.125 MHz
8 802.250 MHz
Approximately 3 seconds after the last actuation of
a key, the letters "CH" will stop flashing and the unit
will exit the channel adjusting mode.
4) Switch on the receiver and set it to the same trans-
mission channel (see instruction manual of the
receiver).
Switch on the audio unit (mixer or amplifier)
connected to the receiver.
5) Speak/sing into the microphone. The level of the
audio signal transmitted is displayed on the receiver.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
or (7)
, the channels are
Channel Frequency
9 803.625 MHz
10 805.250 MHz
11 805.750 MHz
12 808.625 MHz
13 809.125 MHz
14 810.000 MHz
15 813.250 MHz
16 813.750 MHz
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
6) After the channel adjustment, replace the plastic
cap (2).
For colour coding of the transmitter, the cap can
also be replaced by one of the supplied coloured ID
caps.
7) To switch off the microphone after operation, set the
switch "POWER" (3) to "OFF". The display shortly
indicates and is then completely extinguished.
6 Replacement Microphone Cartridges
The following replacement microphone cartridges are
available from the "img Stage Line" range:
model MD-870 (order No. 23.3430)
dynamic original cartridge of the TXS-890HT with
hypercardioid characteristic, ideally suited for
speech and vocals in DJ and entertainer applica-
tions
model MD-872 (order No. 23.3440)
capacitor cartridge with supercardioid characteri-
stic, ideally suited for vocals, particularly for musi-
cians and stage applications

7 Specifications

Approval No.:. . . . . . .
Type of unit: . . . . . . . . dynamic hand-held micro-
Radio frequency range: 790 – 814 MHz, divided into
Audio frequency range: 50 – 16 000 Hz
Frequency stability: . . ±0.005 %
Transmitting power: . . < 10 mW (EIRP)
Ambient temperature: 0 – 40 °C
Power supply: . . . . . . two 1.5 V batteries of size
Dimensions:. . . . . . . . Ø 50 mm x 260 mm
Weight: . . . . . . . . . . . 350 g
According to the manufacturer.
Subject to technical modification.
0197
!
phone with PLL multifre-
quency transmitter
16 channels
(see table, chapter 5)
AA (R6)
GB
7