Taking Into Operation; Remote Control; Switching On; Switching Off - Truma S 5004 Gebrauchsanweisung Und Einbauanweisung

Taking into operation

Before commissioning this additional device, please read and
observe the operating instructions enclosed with the heater.

Remote control

The device is operated via a remote control (1) with an infra-
red transmitter (IR remote control) and an infrared receiver
installed in the cover (2). To carry out the individual switching
commands, the remote control must always be pointed at the
infrared receiver.
2
Fig. 1
g
c
f
Fig. 2
a = Button "On / Off"
b = Setting the brightness of the flame and embers
c = Setting the volume
d = Selecting the crackling noises
e = Selecting the flame effect
f = Setting the flame speed
g = Function display (every touch of a button is acknowl-
edged when the LED shines)
h = Infrared transmitter

Switching on

Switch on the flame effect via the button (a) "On / Off" on
the remote control. The last selected settings are used.
Setting the brightness
Set the brightness of the flame and embers using the buttons (b)
"+" or "-".
Set the volume
Set the volume using the buttons (c) "+" or "-".
Set the cracking noises
Repeated pressing of the button (d) can call up two different
crackling noises one after another.
1
h
a
b
d
e
Set the flame effect
Repeated pressing of the button (e) can call up two different
flame effects one after another.
The following effects are available:
– Embers
– Embers with small flame
– Embers with large flame
Set the flame speed
Repeated pressing of the key (f) can call up two different
flame speeds one after another.

Switching off

The flame effect is switched off by pressing (a) "On / Off" on
the remote control. The last selected settings are used.

Manual switching on / off / default setting

Switching off
The flame effect can be
switched off using
a button on the lower side
of the cover.
Switching on
Pressing the button – for
around 1 second – switches
on the flame effect using the
last selected settings.
Default setting
Pressing the key – for approx. 3 seconds – resets the settings
of the flame effect to the works settings.
Changing the battery in the IR remote
control
Please be sure to use leak-proof micro-batteries only,
type LR 3, AM4, AAA, MN 2400 (1.5 V).
The battery compartment is located on the rear of the remote
control unit.
When fitting new batteries, ensure the
polarity (positive / negative) is correct!
unit. Remove the batteries if the remote
control is not going to be used for an
extended period.
Fig. 4
No claims under guarantee will be considered for dam-
age caused by leaking batteries.
Before throwing away a defective remote control, it is essen-
tial that the batteries be removed and disposed of in the prop-
er manner.
Dead and used batteries may leak
and damage the remote control
Fig. 3
7