Beyerdynamic MCW-D 100 Bedienungsanleitung Seite 47

Top view MCW-D 1043 chairman microphone unit
(5)
(7)
(9) (10)
(8)
3.2.2 Switching on / off
MCW-D 1041
(7)
(8)
MCW-D 100
(2)
(3)
(5)
(6)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(11)
(12)
MCW-D 1043
Switching on
• The microphone units have no separate on/off switch. They are switched
on and off with the microphone button (8).
• By pressing the button briefly, the microphone unit is switched on. The
LED (7) flashes for a moment and the green LED (2) on the rear is illuminated.
Switching off
(7)
• By pressing the button for more than 2 seconds the microphone unit is
switched off and the LED (7) will illuminate twice orange briefly.
(8)
• If you press the standby button (2) of the control unit for more than 4
seconds, you switch off all switched-on MCW-D microphone units within the
range of the MCW-D 200 control unit.
• Furthermore, the microphone units are switched off automatically, when
they do not receive a signal from the control unit for more than 1 minute.
Gooseneck microphone with illuminated ring
Loudspeaker
LED to indicate the function (green / red)
Microphone button
Clear button for clearing the delegate microphone units
Function button for optional functions (refer to chapter 4.3)
LC-Display
Buttons for adjustments
Important:
• If the microphone unit is out of range of the MCW-D 100 control
unit the LED (7) will flash red. After 1 minute the microphone unit
will switch off automatically.
• If the system should fail to operate, i.e. the microphone unit is
switched on but no sound is heard, press the reset button (3) of
the control unit. Should the system still fail to operate, please
check the configuration with the MCW-D Editor Software.
47