Waeco MyFridge MF-1W Bedienungsanleitung Seite 17

_MF-1W.book Seite 17 Freitag, 7. Dezember 2007 4:20 16
MyFridge
➤ If you want to run the device on a 12V socket, connect the 12V cable
(1 3, page 3).
➤ If you want to operate the device with batteries insert the batteries, if
necessary (see the "Inserting/replacing the batteries" chapter on
page 18).
Note
You also can use following rechargeable batteries: (AA) NiMH,
1.2 Volt, 2100 mAh.
Only use batteries/rechargeable batteries of the same kind.
6.2 Cooling wine
Switching on the device
➤ Switch the function switch (2 2, page 3) to "ON".
➤ Press the "POWER" button (2 6, page 3) to switch on the device.
✓ The display switches on and shows the current cooling temperature in C°.
➤ To cool a bottle, place it standing vertically into the device.
Setting the temperature
You can set the temperature within a range from +5 °C to +20 °C.
Note
The cooling capacity is influenced by the ambient temperature.
➤ Press the "TEMP –" button (2 5, page 3) to decrease the desired
cooling temperature by 1 °C , or press the "TEMP +" button (2 7, page 3)
to increase the desired cooling temperature by 1 °C.
✓ The cooling temperature in °C that you just set flashes in the display for
few seconds. Then the current cooling temperature is displayed again.
Switching off the device
➤ To end the cooling process, press the "POWER" button (2 6, page 3).
✓ The display switches off, and the bottle ceases to be cooled.
Operation
17