Installation At A Trussing System; Connections; Connection With The Mains; Outputs - EuroLite AB-410 Bedienungsanleitung

5.2 Installation at a trussing system

Caution: Trussing installations may cause severe injuries when crashing down! If you have doubts
concerning the safety of a possible installation, do NOT install the trussing!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the
installation's weight.
For suspending crossbeams, Alu-Bars, etc. always use a minimum of two hooks.
Attach the upper fixation of a C-hook to the crossbeam and tighten the fixation screw. Attach the Alubar to
the lower fixation of a C-hook and tighten the fixation screw.
At the suspended part, always install a safety-rope that can hold at least 12 times the weight of the
installation. You must only use safety-ropes with screw-on carabines. Pull the safety-rope through the
attachment eyelet and over the trussing system or a safe fixation spot. Insert the end in the carabine and
tighten the safety screw.
The trussing system must always be earthed!
Before taking into operation for the first time, the installation has to be approved by an expert!

5.3 Connections

5.3.1 Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.

5.3.2 Outputs

Output is via 4 safety sockets.
Connect your loads via the output-sockets. The maximum load per channel is 3,680 W (resistive). Please
note that the maximum current of 16 A must never be exceeded.
Fixation point Fixation point
CH-1 CH-2
5 kg Safety rope 5 kg
DANGER TO LIFE!
International
L
N
Occupation: Fixation point Typ/Type: AB-410 Vor Gebrauch Anleitung lesen. Gerät
Spannungsversorgung/Power supply: 230 V AC, 50 Hz ~ Max. Gesamtleistung/Max. power output: 14490 W vor Feuchtigkeit schützen! Gefahr eines
CH-1 1+9 Max. Gesamtstrom/Max. total current: 63 A elektrischen Schlages, niemals das Gerät öffnen! Im Geräteinnern befinden
CH-2 2+10 Max. Nennleistung/Kanal/Max. output/channel: 3680 W Max. Nennstrom/Kanal/Max. current/channel: 16 A und Servicearbeiten nur durch autorisier- sich keine zu wartenden Teile. Wartungs-
CH-3 3+11 Max. Tragfähigk./Aufnahmepunkt/Max. load/fixat. point: 5 kg ten Fachhandel! Sicherungsseile für
CH-4 4+12 CH-3 Max. verteilte Tragfähigkeit/Max. spaced braceload: 30 kg Max. zentrale Tragfähigkeit/Max. centered braceload: 25 kg Lasten und Eigensicherung verwenden! Beim Installieren der Leuchten Warnhin-
CH-5 5+13 Gewicht/Weight: 4 kg weise beachten! Read user manual before use. Keep away
CH-6 6+14 Max. Nutzungsdauer/Max. service life: 10 y Inspektionen/Inspections: 1/y from moisture! Risk of electric shock,
5 kg Baujahr/Year of construction: 2002 serviceable parts inside the device. Main- never open the housing! There are no Safety rope
authorized dealers. Use safety-ropes for tenance and service operations only by
Max. centered UP eurolite MADE IN CHINA ® loads and for device itself! Respect all
braceload: 25 kg warnings when rigging the luminaires!
17
Fixation point
CH-4
5 kg