Pairing It With Your Phone - Jabra BT2035 Bedienungsanleitung

PairinG it With your Phone

headsets are connected to phones using a procedure called 'pairing' .
by following a few simple steps, a phone can be paired with a headset
in a matter of minutes .
1. Put the headset in pairing mode
- When you turn on your Jabra bT2035 for the first time, the headset
will automatically start up on pairing mode – i . e . it is discoverable
for your phone . When the headset is in pairing mode the led is
constantly lit .
2. Set your
- follow your phone's instruction guide . first make sure that
is activated on your mobile phone . Then set your
phone to discover the headset . This usually involves going
to a 'setup, ' 'connect' or '
selecting the option to 'discover' or 'add' a
3. Your phone will find the Jabra BT2035
- your phone will find the headset under name "
your phone then asks if you want to pair with the headset .
accept by pressing 'yes' or 'ok' on the phone and confirm with
the passkey or Pin = 0000 (4 zeros) . your phone will confirm
when pairing is complete .
CONNECTIVITY
MobilSurf
BLUETOOTH
Infrared port
Wap options
Synchronization
Networks
SELECT
in case of unsuccessful pairing, put the Jabra bT2035 into pairing
mode manually . make sure the headset is off . Press and hold the
answer/end button for approximately 5 seconds until the led has
a constant light . T he led will flash before the light is constant – keep
holding down the button until light is constant .
* Phone dependent
phone to 'discover' the Jabra BT2035
DEVICES FOUND
Bluetooth Headset
SELECT
Jabra bT2035
' menu on your phone and
Bluetooth Headset
Passkey:
****
OK
device . *
headset" .
HANDSFREE
Bluetooth
Headset is now
ready for use
SELECT
5