Declaration Of Conformity; Installation Instructions - Truma Kaminfeuer Gebrauchsanweisung

Declaration of conformity

1. Information about the manufacturer:
Name: Truma Gerätetechnik GmbH & Co. KG
Address: Wernher-von-Braun-Str. 12,
85640 Putzbrunn, Germany
2. Device identification:
Model: Front case with flame effect
Versions: KF
3. Meets the requirements of the following directives:
Low Voltage Directive 2006/95/EC
Radio Interference Suppression UN ECE R 10
EMC Directive 2004/108/EC
End-of-Life Vehicle Directive 2000/53/EC
and bears the type approval number E1 10R-046531 and the
CE mark.
4. Basis for the proof of conformity:
EN 60335-1:2012; EN 55014-1:2006 + A1:2009; EN
62233:2008; EN 55014-2:1997 + A1:2001 + A2:2008
5. Monitoring body:
Federal Motor Transport Authority (Kraftfahrt-Bundesamt)
6. Signatory details:
Frank Oster
Managing Director Putzbrunn, 06.05.2015

Installation instructions

The appliance must only be installed and repaired by
an expert. Read the installation instructions carefully before
working, and then comply with them!
Installation of the front case with
flame effect
Attach the connector cable to the PCB (X1) on the back of the
cover. Attach the plug until it engages.
Figure 5
– Screw on the front case with flame effect at the location
provided using 4 screws (not included).
Figure 6
12 V electrical connection
Electrical lines, switching and control equipment for
heaters must be in locations that will not cause the oper-
ation thereof to be adversely affected under normal operating
conditions. The breakthroughs of all lines leading to the out-
side must be protected from splash water.
12 V connector cable with fuse (3.15 AT)
Connect the appliance to the fused vehicle's electrical system
(central electrical system max. 10 A). Pay attention to polarity.
No other consumers must be connected to the connector
cable!
When power supplies are being used, it must be noted
that the output voltage is between 11 V and 15 V and
the alternating current ripple is < 1.2 Vss.
3,15 AT
9