NO.
Name
11
RIGHT " − " key
12
RIGHT " + " key
13
PATTERN key
14
DATA key
COUNTER key
15
NEEDLE key
16
17
LOOPER key
18
LENGTH key
19
STITCHES
(Number of stitches
of parallel)
key
20
STITCHES
(Number of stitches
of eyelet)
key
SPACE
21
(Cut space)
key
22
SPACE
(Eyelet
space) key
Note 1 : When changing the set value, operate the panel in the state that the sewing LED has gone out.
Note 2 : When both the before-cut and after-cut knives are not selected (set value : "0"), the data without knife is
selected.
Note 3 : Effective / ineffective of knife operation can be selected in case of the before-cut and after-cut knives,
however, in case of the data without knife, the knife operation cannot be performed.
14
中国缝纫机设备网
Description
This key subtracts various
data.
This key adds various data.
This key performs display
and setting of pattern No.
This key performs display
and setting of data No.
This key performs display
of counter.
This key performs display
a n d s e t t i n g o f n e e d l e
thread tension data.
This key performs display
a n d s e t t i n g o f l o o p e r
thread tension data.
This key sets the length to
be sewn.
Note 1
This key sets the number
of stitches of the parallel
section.
Note 1
This key sets the number
of stitches of the eyelet
section.
Note 1
This key sets clearance
between cloth cutting knife
and sewing at the parallel
section. Note 1
This key sets clearance
between cloth cutting knife
and sewing at the eyelet
section.
NO.
Name
23
LENGTH
(Taper bar
length) key
Note 1
STITCHES
24
(Number
of stitches
of taper bar)
key
25
OFFSET
(Taper bar
offset) key
26
MAX
(Sewing
speed) key
27
EYELET
(Eyelet speed
setting) key
28
KNIFE
(Knife ON/
OFF)key
29
CB
(Before-cut
knife) key
CA
30
(After-cut
knife) key
31
SHAPE
(Knife No.)
key
32
AUTO
(Auto
operation)
key
33
OPEN
(Cloth
open) key
34
ADJUST
(Knife adjust)
key
35
FUNCTION
(Function) key
www.fengrenjicn.com
Description
This key sets sewing length
of taper bar.
Note 1
This key sets the number
of stitches of taper bar.
Note 1
T h i s k e y s e t s t h e s l i p
amount of taper bar.
Note 1
This key performs setting
of sewing speed.
Note 1
This key performs setting
of reduced speed at eyelet
section.
Note 1
This key sets effective/
ineffective of knife.
Note 3
This key performs data
setting of before-cut knife.
Note 2
This key performs data
setting of after-cut knife.
Note 2
This key selects the No. of
kind of knife to be used.
Note 1
This key performs change-
o v e r o f a u t o m a t i c a n d
manual operation modes.
The mode becomes the
one operating with the cloth
open mechanism opened.
The mode becomes the
one of cloth cutting knife
adjustment by turning ON
the power with this key
held pressed.
This key can be changed to
optional data setting function
key with the memory switch.
At the time of delivery
F1 : Knife position adjustment (No. 8)
F2 : Copy destination No. (No. 80)