VS A2705 Bedienungsanleitung Seite 10

Caution!
(1)
(2)
(3)
1. Mounting the monitor arm
Place guide gudgeon (2) on the cable lead-through and
screw anti-turn lock (3) to the premounted retaining plate
with the supplied screw (1). In so doing, pull anti-turn lock
(3) in the cable lead-through as far forwards as possible.
Make sure additional lock nut (4) is tightened from below to
prevent the connection from unintentionally coming loose.
Then attach the monitor arm and secure / limit against ex-
cessive turning with grub screw (5).
Caution! Anti-turn lock (3) must be seated without
play in the cable lead-through.
Caution! Do not crush the cables.
Caution! Make sure there is sufficient cable length for
every monitor position.
To mount and remove the monitor on the monitor arm and to
adjust the monitor arm, please refer to the manufacturer's
supplied instructions.
10
(1)
(6)
(5)
(2)
(3)
(4)
(5)
(4)
2. Mounting the lamp:
Screw guide sleeve (7) through the cable lead-through to
the premounted retaining plate. Make sure additional lock
nut (4) is tightened from below to prevent the connection
from unintentionally coming loose.
Then attach the lamp arm and place in the desired position.
To operate and use the lamp, please refer to the manu-
facturer's instructions.
(7)
(4)