Rear Spacers; Door Reversibility - Zanussi ZFT11407WA Benutzerinformation

Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be
guaranteed within the specified
temperature range. If you have any
doubts regarding where to install the
appliance, please turn to the vendor,
to our customer service or to the
nearest Authorised Service Centre.
LEVELLING
When placing the appliance ensure that it stands
level. This can be achieved by two adjustable feet
at the bottom in front.
LOCATION
It must be possible to disconnect the
appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely
around the back of the cabinet. To ensure best
performance, if the appliance is positioned below
an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the
appliance should not be positioned below
overhanging wall units. Accurate levelling is
ensured by one or more adjustable feet at the base
of the cabinet.
100 mm
15 mm

REAR SPACERS

In the bag with the documentation, there are two
spacers which must be fitted as shown in the
figure.
1. Fit the spacers into the holes. Make sure that
the arrow (A) is positioned as shown in the
picture.
2. Turn counter-clockwise the spacers through
45° until they lock into place.

DOOR REVERSIBILITY

WARNING! Before carrying out any
operations, remove the plug from the
power socket.
CAUTION! To carry out the following
operations, we suggest that this be
made with another person that will
keep a firm hold on the doors of the
appliance during the operations.
1. Tilt back the appliance carefully so that the
compressor cannot touch the floor.
2. Unscrew both adjustable feet.
15 mm
2
1
45°
A
45°
2
45