Axis 1650 Installationsanleitung Seite 14

Page 14
4. Right-click the device you would like to use (example:
WIA Canon MF3110) and select Properties.
Events
Select and select the event
5.
Button.
Under Actions, select the option
6.
MF ToolBox
select
7. Click [OK].
Now you have prepared your computer for scanning via AXIS 1650.
Note: These steps are just needed prior to the first scanning from the computer.
Starting a Scan from the Canon Device
When you have established a connection between your computer and the scanner with AXIS
ScanClient, place the object to be scanned on the scanner flatbed.
1. If the Canon device is in Energy Save mode, press its [Energy Saver key].
2. Press [Scan] on the Canon device.
3. Press [Start] on the Canon device.
4. The scanning will start.
5. When ready, remove the scanned object from the flatbed and walk back to your
computer.
6. Close the receiving program on your computer and end the scanning session (see below).
Canon MF3110 Scan
Start this program
in the list.
AXIS 1650 Set-up Instructions
and