Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Consult the designs in the front pages referenced in the text by alphabet letters.
Use: The cooker hood is provided with an upper air exit A with
connection ring B, a discharge tube (not provided) should be
mounted on the ring for discharging fumes and vapours externally
(Suction Version).
Where external discharge of cooking fumes and vapours is not
possible the cooker hood may be used in the filter version by
mounting a carbon filter, a discharge tube should be connected
to the ring in order to expel the fumes above the cabinet. The
models without suction motors function only in the suction version
and must be connected to a peripheral suction unit (not supplied).
Installation: The cooker hood must be positioned at least 65 cm
from the cook top for electrical cookers and 75 cm for gas or
mixed cookers. This cooker hood is designed to be fitted to a
cabinet or similar support.
Carry out the following instructions for affixing the cooker hood:
Create an opening in the bottom of the cabinet to insert the cooker
hood, and drill a hole on the top of the cabinet to fit the discharge
tube, connect the cooker hood to an external pipe, predispose the
electrical connection, remove the grill or the anti-grease filter,
remove the frame C (if provided) by pressing on the two release
hooks D (according to the model in possession, the release hook
button D may be located externally or inside the cooker hood
below the grease filter / grill), insert the cooker hood in the
opening (lock in the lateral clasps E if provided by tightening the
locking screws F), finally fix the cooker hood to the cabinet with
wood screws G supplied. Remount the frame C (if provided), and
suction grill H.
Electrical connection: The electrical tension must correspond
to the tension noted on the label placed inside the cooker hood.
Connect the electrical plug, where provided, to the an easily
accessible outlet in conformity with local standards in force.
Where an electrical plug is not provided (for direct connection to
electrical network) place a standards approved bipolar switch
with an aperture distance of not less than 3mm (accessible) from
the contacts.
Caution: This appliance is designed to be operated by adults.
Children should not be allowed to tamper with the controls or play
with the appliance.
Do not use the cooker hood where the grill is not correctly fixed!
The suctioned air must not be conveyed in the same channel
used for fumes discharged by appliances powered by other than
electricity. The environment must always be adequately aerated
when the cooker hood and other appliances powered by other
than electricity are used at the same time. Flambé cooking with
a cooker hood is prohibited. The use of a free flame is damaging
to the filters and may cause fire accidents, therefore free flame
cooking must be avoided. Frying of foods must be kept under
close control in order to avoid overheated oil catching fire. Carry
out fumes discharging in accordance with the regulations in force
by local laws for safety and technical restrictions.
Operation
The control panel is supplied with a switch to select the suction
speed and lighting.
The switch is located on the side of the suction grill H.
Use the higher suction speed for greater levels of cooking
All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in
this manual, is declined.
Closely follow the instructions set out in this manual
vapours. It is recommended to switch on the appliance 5 minutes
prior to cooking and for at least 15 minutes after cooking.
Maintenance
Prior to any maintenance operation ensure that the cooker
hood is disconnected from the electrical outlet.
Anti-grease filter -
May be one of the following if located inside the support
grill:
Paper filter should be replaced once a month or sooner, if
coloured on the upper side or when the coloration is visible in the
grill holes.
Sponge filter should be washed with hot soapy water once a
month and replaced every 5/6 washes.
Metallic filter should be cleaned once a month, with non abrasive
detergents, by hand or in dishwasher at low temperature and
short cycle.
When washed in a dish washer, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
To access the grease filter J open the suction grill H via the
release hooks L and free from the supports K.
Some models are provided with a metallic filter M without
support grill, these should be washed as described above and
removed from their housing by pressing the N handles towards
the bottom.
Carbon Filter (only for filter version)
The active carbon filter is not washable nor reusable. The active
carbon filter captures all the undesirable cooking vapours. It is
mounted inside the cooker hood covering the motor protection
grill, it should be replaced every 4 months – and may be one of
the following:
Rectangular: position the filter P in order to cover the motor
protection grill and turn the handle clockwise until locked-in, for
dismounting follow instructions in reverse.
Bayonet Circular-Insert position the filter in the centre (in
certain cases use the Z hooks for centring the filter) in order to
cover the motor protection grill ensuring that the X reference on
the carbon filter corresponds to the Y reference on the conveyor,
then turn clockwise; for dismounting follow instructions in reverse.
Cleaning: The cooker hood should be cleaned regularly internally
and externally.
For cleaning use a cloth moistened with neutral liquid detergents.
Avoid abrasive detergents.
Failure to carry out the basic standards of the cleaning of the
cooker hood and replacement of the filters may cause fire
risks.
Lightbulb replacement: Remove the anti-grease filter sup-
port grill or the anti-grease filter to access the lamp area. Re-
move the damaged lightbulb and replace with an incandescent
oval bulb maximum 40W E14. In the case where model is
provided with a halogen lightbulb, replace with halogen bulb of
20W (GU5.3 - Ø50mm).
Werbung
