Herunterladen Inhalt Inhalt Diese Seite drucken

Making The Connections; Subwoofer; Satellite Speakers; Connecting A Home Cinema System - Omnitronic BOB Serie Bedienungsanleitung

Active pa system
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

6

MAKING THE CONNECTIONS

Subwoofer

Switch off the subwoofer and the units to be connected before making or changing the connections. As
signal source, audio units with line level output (e.g. mixer, preamplifier) can be connected to the inputs via
XLR and 6.3 mm plugs, balanced and unbalanced. Alternatively, unbalanced RCA jacks are provided. The
inputs are designed for stereo signals (R = right channel, L = left channel). When connecting a mono device
to the combo inputs, only use the left jack. At the balanced XLR outputs LINK OUT the input signal fed
through is available. This output allows connecting the input of another active speaker system for additional
PA applications. Finally, connect the supplied power supply cable to the corresponding input and the mains
plug to an outlet (230 V, 50 Hz). The subwoofer can also be operated with 115 V, 60 Hz. For this purpose,
set the voltage selector switch to the 115 V position.
A good cable run improves the sound quality remarkably. Signal cables should be short and direct, since
high frequencies will mostly be absorbed if cables are unnecessarily long. Besides that a longer cable may
lead to humming and noise trouble. If long cable runs are unavoidable, you should use balanced cables. In
order to obtain highest sound quality, only use high-quality cables for connecting the devices. Make sure that
the cables are properly fixed.

Satellite speakers

Connect the satellite speakers to the Speaker outputs of the
subwoofer using the included connection cables. The minimum
acceptable impedance for each output is 4 ohms. Thus, up to 4
satellite speakers can be connected to each output. For locking
the connection turn the plug to the right. For unlocking pull the
unlock button and turn the plug to the left and pull it out of the
socket.
Use the screw terminals to interconnect the satellite speakers. Matching cables are available
as accessory. Make sure that all speakers have the same polarity. To facilitate handling, the
terminals can be removed from their plug-in connections and replaced after connection.

Connecting a home cinema system

Connect the subwoofer to a passive signal output of the AV receiver and the satellite speakers to the
amplified outputs of the AV receiver.
22

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Bob-4Bob-10a

Inhaltsverzeichnis