Before Using The Appliance - Argo 3SC Installationsanleitung

BEFORE USING THE APPLIANCE

Check that the power supply at the location where the air conditioner is going to be used is 220-240V ~ 50Hz .
G
Make sure that the electrical installation is suitable to supply continuously current necessary for the air conditioner in
G
addition to that already used by other electric appliances (white goods, lighting). See the max electric input indicated
on the name plate positioned on the air conditioner.
The installation of a double-pole switch, protected by 10 A fuses of the delayed type, upstream the electricity wall socket,
G
is recommended.
The unit has to be connected according to the local electrical rules.
G
Make sure that circuit breakers, fuses, etc, are of sufficient capacity to handle a start-up current of 20 A (generally less
G
then 1 second).
Do not install the air conditioner where it could be wetted by drops of water (i.e. in laundries).
G
Before connecting the air conditioner to a power socket, make sure that the socket is provided with an earth connection
G
in compliance with local codes.
Never use the power plug as a mean to start or stop the air conditioner: always use the ON/OFF button of the remote
G
control unit or the operation button on the unit.
WARNING! Do not stick anything into the air outlet of the air conditioner. This is very dangerous because the fan is rotating
G
at high speed.
WARNING!
G
The air conditioner is provided with a time-guard system, which does not allow re-starting of compressor until after 3
minutes from a previous stop.
Make sure that there are no obstacles around the unit affecting the free circulation of air. Do not block the air intakes
G
and outlet of the unit with curtains or other. Never put objects on the top of the unit.
When you switch on the air conditioner for the first time, it reaches the maximum efficiency after at least one hour of
G
operation.
The manufacturer assumes no responsibilities if the safety regulations or local codes are not observed.
G
WARNING
Always unplug the unit from the power socket before moving or cleaning it and, in case you should remove it, discharge
the eventual condensate water inside the bottom plate.
7
EG