Specifications; Circular Saw Safety Warnings - Maktec MT582 Betriebsanleitung

ENGLISH
(Original instructions)
1 Depth guide
2 Lever
3 Clamping screw
4 Base plate
5 Lock button/Lock-off button
6 Switch trigger

SPECIFICATIONS

Max. cutting depth
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and instruc-
tions may result in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future reference.

CIRCULAR SAW SAFETY WARNINGS

Cutting procedures
1. DANGER: Keep hands away from cutting area
and the blade. Keep your second hand on
auxiliary handle, or motor housing. If both hands
are holding the saw, they cannot be cut by the blade.
2. Do not reach underneath the workpiece. The
guard cannot protect you from the blade below the
workpiece.
4
Explanation of general view
7 Hex wrench
8 Shaft lock
9 Inner flange
10 Saw blade
11 Outer flange
12 Hex bolt
Model
Blade diameter
when using 190 mm diameter blade
when using 185 mm diameter blade
–1
No load speed (min )
Overall length
Net weight
Safety class
ENE028-1
ENF002-2
GEA010-1
GEB013-6
13 Mounting shaft
14 Screw
15 Rip fence
16 Limit mark
17 Screwdriver
18 Brush holder cap
at 90°
at 45°
at 90°
at 45°
3. Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth
should be visible below the workpiece.
4. Never hold piece being cut in your hands or
across your leg. Secure the workpiece to a
stable platform. It is important to support the work
properly to minimize body exposure, blade binding,
or loss of control.
A typical illustration of proper hand support, work-
piece support, and supply cord routing (if applicable).
5. Hold the power tool by insulated gripping
surfaces only, when performing an operation
where the cutting tool may contact hidden wiring
or its own cord. Contact with a "live" wire will also
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
6. When ripping, always use a rip fence or straight
edge guide. This improves the accuracy of cut and
reduces the chance of blade binding.
7. Always use blades with correct size and shape
(diamond versus round) of arbour holes. Blades
that do not match the mounting hardware of the saw
will run eccentrically, causing loss of control.
MT582
185 mm – 190 mm
68 mm
46 mm
66 mm
44 mm
4,900
297 mm
4.0 kg
/II