Operation - INVENTOR CLCO290-09 Bedienungsanleitung

|Operation

Other features
SLEEP/ECO operation
This feature can be activated with the use of
the remote control only. When SLEEP mode is
activated the set temperature will increase by
1C/2F within 30 minutes. The set temperature
will again increase by another 1C/2F during
the next half hour. This new temperature will
be maintained for the next 7 hours, after the
duration of the above time frame the unit will
return to the initial set temperature and ending
the SLEEP mode. This feature is not available
under DRY or FAN mode.
AUTO-RESTART
In the event of power loss the unit will regain
operation, once power resumes, with the last
settings.
AIR FLOW DIRECTION ADJUSTMENT
Adjust the air flow direction manually:
-The louver can be set to the desired position
manually.
-Do not place any heavy objects or other loads
on the louver, doing so will cause damage to the
unit.
-Keep the louver fully opened during operation.
WAIT 3 MINUTES BEFORE RESUMING
OPERATION
Once the unit has stopped its operation, it can
not be restarted within the first 3 minutes, for
the protection of the device. Operation will
automatically restart after 3 minutes.
16
Water drainage
When under dehumidifying mode, remove the
drain plug for the back of the unit and install the
drain connector (5/8 universal female mender)
with a 3/4 hose (may be purchased locally). For
models without the drain connector, please
attach the drain hose to the outlet, while placing
the other side of the hose directly over the
drainage port of your basement floor.
Remove the
drain plug
NOTE: Be certain the hose is secure without
any leaking. Direct the hose toward the drain,
in such a manner that there are no breaks or
bents securing smooth water flow. When the
continuous drain hose is not of use, ensure the
drain plug is installed firmly to prevent possible
leakage.
When the water level of the bottom tray
reaches a predetermined level, the unit beeps
8 times; the digital display area shows "PI". At
this time the air conditioning/dehumidification
process will immediately stop. However, the fan
motor will continue to operate (this is normal).
Carefully move the unit to a drain location,
remove the bottom drain plug and let the
water drain. Re-install the bottom drain plug
and restart the machine until the "PI" symbol
disappears. If the error persists, please call for
service.
NOTE: Be sure to reinstall the bottom drain
plug firmly to revent leakage before using the
unit.
Bottom drain
plug
Continuous
drain hose
EN