Fault Finding; Technical Data; Possible Cause; Fault Correction - Grizzly ERT 45 Pro Bedienungsanleitung

Fault Finding

Problem
Device vibrates
Device does not start
Inferior cutting performance

Technical Data

Electrical lawn trimmer
Rated input voltage ....................................... 230V~, 50 Hz ............... 230V~, 50 Hz .............. 230V~, 50 Hz
Input power ............................................................ 400 Watt ....................... 450 Watt ...................... 500 Watt
Idle speed .......................................................... 10.200 rpm ................... 10.200 rpm .................. 10.200 rpm
Weight ...................................................................... 3,25 kg ......................... 3,25 kg ......................... 3,25 kg
Cutting circle ........................................................... 300 mm ........................ 300 mm ....................... 300 mm
Double line ............................................................... 2 x 4 m ......................... 2 x 5 m ......................... 2 x 5 m
Thread thickness ..................................................... 1,4 mm ......................... 1,5 mm ........................ 1,5 mm
Blade ............................................................................... no ............................... opt. ............................... yes
Safety class ...............................................................
Guaranteed sound power level ............................ 96 dB (A) ..................... 96 dB (A) ..................... 96 dB (A)
Sound pressure level ........................................ 84,9 dB (A) .................. 84,9 dB (A) .................. 84,9 dB (A)
Vibration at the handle ......................................... 2,27 m/s
Noise and vibration values were determined according to the standards and stipulations mentioned in the
declaration of conformity.
Technical and optical changes can be carried out in the course of further development without notice. All
dimensions, references and information of this instruction manual are therefore without guarantee. Legal
claims, which are made on the basis of the instruction manual, cannot thus be considered as valid.

Possible cause

Spool or blade soiled
Spool or blade defective
Mains voltage not applied
On/Off switch defective
Worn carbon brushes
Defective motor
Thread spool does not have
sufficient line
Thread is not guided out of
spool or extends from the
spool on one side only
ERT 40 Pro
tap'n go automatic .............. fully automatic ............. fully automatic

Fault correction

Clean spool (see chap. on replacing
spool)
Clean blade
Replace spool or blade (see chap. on
replacing the cutting equipment)
Check plug socket, cable, line and
plug, where appropriate, have
repaired through electrical specialist
Repair through customer service
ERT 40 Pro: Adjusting nylon line (see
chap. Operating the Lawn Trimmer
eplace spool (see chap. on replacing
the cutting equipment)
Remove spool and thread line through
the openings to outside, mount spool
again.
ERT 45 Pro
II ..............................
...................... 2,27 m/s
2
GB
ERT 55 Pro
II ..............................
..................... 2,27 m/s
2
II
2
39 39