Waeco PerfectView CAM16 Montage- Und Bedienungsanleitung Seite 29

_RV-16.book Seite 29 Donnerstag, 3. Januar 2008 1:12 13
PerfectView CAM16
– The location on the body where you wish to attach the housing must be rigid
enough to allow the housing holder to be tightly fastened.
Check beforehand that there is sufficient room for the drill head to come out on the
other side (see 2, page 4).
If you are not sure about the location you have chosen, consult the vehicle
manufacturer or dealer.
Tip!
We recommend greasing the threads of the bolts to prevent corrosion.
When mounting the camera, proceed as follows:
➤
Hold the housing holder on the chosen location and mark at least two different points
for the drill holes (8, page 7).
If you would like to screw the camera on with self-tapping screws (9, page 7).
The holder may only be attached to steel panels with a minimum thickness of
1.5 mm using self-tapping screws.
➤
Using a hammer (1 6, page 3) and centre punch (1 5, page 3), gently pre-punch
the previously marked points to prevent the drill head from slipping off.
➤
Drill Ø 3 mm holes at the points you have just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Screw the housing holder on with the 4 x 25 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted through the
body shell (0, page 7)
Ensure that that nuts cannot be pulled through the body shell when they are
tightened.
➤
Using a hammer and centre punch, gently pre-punch the previously marked points to
prevent the drill head from slipping off.
➤
Drill Ø 4.5 mm holes at the points you have just marked.
➤
Screw the housing holder on with the M4 x 25 mm threaded screws.
Creating a through-hole for the camera connection cable
If possible, use available openings – such as ventilation grilles – to feed the
connection cables through. If there are no existing openings, you must drill a
hole with a 13 mm diameter. Check beforehand that there is sufficient room for
the drill head to come out on the other side.
➤
Drill a hole of Ø 13 mm near the camera (a, page 7).
➤
Deburr all drill holes that have been made in the sheet metal and apply rust-
protection.
➤
Place cable sleeves in all sharp edged ducts.
Installing the rear view video camera
29