Mounting And Installation; Mounting / Dismounting - Stahl IS1plus Betriebsanleitung

Mounting and Installation

EN
6 Mounting and Installation
EN
EN
6.1

Mounting / Dismounting

 Mount the device carefully and only in accordance with the safety notes
EN
(see Chapter "Safety").
EN
 Read through the following installation conditions and assembly instructions carefully and
EN
follow them precisely.
EN
6.1.1 Operating Position
EN
 Mount the base exclusively as follows:
• Horizontal mounting position with a reading direction from left,
EN
or
EN
• Vertical mounting position with an upward or downward reading direction.
EN
• Use of a mounting plate is recommended.
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
6.1.2 Mounting on the 9496/35 Base
EN
DANGER! Explosion hazard due to insecure mounting!
EN
Non-compliance may result in serious or even fatal injury.
 Fasten the power module using a safety screw and screwdriver (Torx T20).
EN
EN
10
IS1+ power module for Zone 2 / Division 2
Series 9445/35
20015E00
20016E00
264697 / 944560310010
2018-09-27·BA00·III·en·01