Battery Charger; Control Panel - Husqvarna LC247Li Bedienungsanweisung

LED on the battery
The error LED flashes
The error LED is on

Battery charger

LED on the battery
charger
The error LED flash-
es
The error LED is on

Control panel

For problems, other than those in this section, speak to
your service agent.
Keypad Error code (Num-
ber of flashes)
Error LED flashes 3
5
10
2
9
The product stops 8
0
16
Possible faults
The battery is weak
The temperature in the work environ-
ment is too high or too low
Overvoltage
Cell difference too much (1V)
Possible faults
The temperature in the work en-
vironment is too high or too low
Possible faults
The motor is overloaded
The motor speed drops too
much, and the motor stops
The motor control is too hot
The blade is blocked
Battery error or no signal from
battery
The battery is weak
Battery connector failure
Possible procedure
Charge the battery. See
Use the battery in temperatures between -10°C
and 40°C.
Check that the mains voltage is the same as on
the rating plate on the product.
Remove the battery from the battery charger. Wait
5 seconds and try again to charge the battery. If
the problem continues, speak to an authorised
service agent.
Speak to an approved service agent.
Possible procedure
Use the battery charger in temperatures between 5°C
and 40°C.
Speak to an approved service agent
Possible action
Increase the cutting height. See
the cutting height on page 12 .
Stop the motor and wait until it has be-
come cool
To prevent accidental start turn the safe-
ty key to 0, remove the battery and wait
a minimum 5 seconds. Make sure that
the blade can rotate freely. If the prob-
lem continues, speak to an authorised
service agent
Put the battery in the product correctly
and examine the battery connector. If the
error LED on the battery flashes, see
Battery on page 12 .
Charge the battery. See
battery on page 13 .
Examine the battery connector
Battery on page 15 .
To set
To charge the
429 - 002 - 13.12.2017