Commissioning - Scheppach wox d 700 Bedienungsanleitung

Commissioning

• Before commissioning the safety.
• All protective and auxiliary devices shall be mounted.
• changeover, adjustment, testing and cleaning work carried out with the engine off. Pull the power plug and wait stalling of the
rotating tool.
• The saw is solely for the cross-sectional cutting of firewood with max. 1 meter length constructed
• Regardless of the timber diameter Only one piece with min. Ø 60 mm are placed on the rocker. In the seesaw of wox d700sl sev-
eral logs may be loaded simultaneously, but only so many that the lid can be closed safely
• Functional test before starting work.
• wooden rocker in place.
• pivot the rocker to the saw blade with both hands on the handle.
• Then bring the rocker to the starting position.
• The to be sawn wood may not be fixed by hand.
Tractor attachment
• Attach the circular saw to the 3-point hydraulics of the tractor in
longitudinal direction for cutting firewood.
• The spline shaft stub must be covered with the protective cover.
• The saw shall only be operated with the overload coupling in-
stalled. Fig.1 (included in the scope of delivery) Noises may
emanate from the overload coupling when the rotational speed
is increasing or decreasing.
• When operating, secure the Cardan shaft with the chain to pre-
vent spinning.
• Hang the Cardan shaft in the holder after uncoupling from the
tractor.
• Switch off the tractor and remove the ignition key when leaving
the workplace.
• Use the correct Cardan shaft. We recommend the scheppach
Cardan shaft W100, Art. no. 05018101.
GB
Abb. 1
Seite:79